Feed machine troubleshooting common motor starting difficulties ☆ Cause Remedy ① escape peak voltage is too low then start ② wire area is too small to replace the appropriate fuse wire ③ easy to replace blown fuses consistent with the motor capacity ☆ feed machine Maintenance of 1, hammer hammer with a blunt sharp corners later, you can change the transmission direction using another miter. If the corners at one end of the hammer have been worn, you should use a U-turn, in the U-turn, the hammer should be all the same time, to ensure that the balance of the rotor. After the corners are worn, pig feed machinery, should all be replaced with new hammer, hammer in each weight difference should not exceed 5 grams. 2, sieve (Rhodes) timely replacement of worn or damaged sieve, installation, feed unit price, the sieve with a burr in the side should be smooth side out, feed machine, screen films and chassis to fit close. 3, after the end of each feed processing, feed machine should be cleaned inside and outside, remove dust and dirt in order to avoid feed machine rusty, clogged sieve, bearing box into the dust dirt and avoid causing residual feed deterioration. 4, regular cleaning of exhaust zone, it has a good air permeability, periodically check the cleaning, lubricating parts. 5, feed machine parts have found severe wear and damage should be repaired or replaced, the rotor should be balanced after repair. Feed machine, feed unit price, Constant Machinery (high-quality businesses) are provided by Xingyang Constant farming machinery plant. Road Zhiyuan, temper forward. Constant farming machinery factory Xingyang (www.zzhljzjx.com) (www.zzhljzjx.com) aims to become and you win symbiosis, strategic partners to move forward, more determined to become the machining of the most influential companies, and You leap together, succeed together!